McQuay M5LCX Spezifikationen PDF herunterladen (Seite 25)

M5LCX-2009

CAUTION :

Drilling Holes And Mounting Plate Installation

• Paste the installation plate provided on the desired location on the wall and marks the holes location

accordingly.

• Ensure that the minimum maintenance and servicing space at the top, left and right side of the unit

is reserved.

• Ensure also the levelness of the installation plate.

• Drill the screw mounting holes (minimum 4 screws are required).

• Drill the pipe hole at the location as per plan. (This is only applicable for rear piping outlet installation).

Note: The hole should be drilled slightly lower at outdoor side as per figure below:-

• Fix the installation plate firmly to wall, without tilting to left or right. Use a plumb line, if available.

• Fixing methods:-

WOODEN

REINFORCED CONCRETE BUILDING

NUT ANCHOR

BOLT ANCHOR

• If the condensing unit is operated in an atmosphere containing oils (including machine oils), salt (coastal

area), sulphide gas (near hot spring, oil refinery plant), such substances may lead to failure of the

unit.

• If there is any obstacle higher than 2m, or if there is any obstruction at the upper part of the unit,

please allow more space than the figure indicated in the above table.

Indoor Side

Outdoor Side

72.0

'A'

Screw position in the wall

Dia 65.0mm Hole in the wall

Cautions:

i) Please check the unit weight for each model. Always ensure that the wall is sufficiently strong to

withstand the weight. If not, it is necessary to reinforce the wall with plate, beams or pillars.

ii) The unit cannot be directly fixed onto the wall or the likes. In all cases, the installation plate

provided MUST be used.

Application Information

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 133 134

Keine Kommentare

McQuay M5LCX Spezifikationen Seite 25