is caused by electrical defect while improper application or defects in refrigerant circuit causes “Insuf-
cient cooling ”.
: Faulty : Check : Cause : Remedy
No Cooling ( Unit fails to start)
Evaporator
Fan Motor
Unit Power
Supply
No Voltage or Low Voltage
Single Phase
Components Shorted
Connections Loose
High or Low Voltage
Single Phase
Coil Burnt
Contact Faulty
Contact Faulty
Contact Faulty
Open Compressor Windings
Incorrect Wiring
Correct The Wiring
Change The Compressor
Change The Contacts
Change The Contactor
Change The Contactor
Get The Right Voltage
Get The Right Voltage
Get The Right Voltage
Tighten The Connections
Repair or Replace The Components
Repait The Power Line
Repair Or Replace The Switch
Repair Or Change The Motor
Repair The Contacts
Change The Contactor
Check The Power Supply To The
Motor : Repair When Necessary
Check The Power Supply To The
Motor : Repair When Necessary
Repair or Change If Necessary
Repair or Change The Motor
Change The Contacts
Faulty Fan Motor
Fan Motor Faulty
Other Electrical Component Faulty
Defective Operation Switch
High Voltage or Low Voltage
Single Phase
Coil Burnt
Coil Burnt
Fuse For
Operation
Circuit
Overcurrent
Relay For
Evaporator Fan
Evaporator Fan
Contactor
Overcurrent
Relay For
Condenser Fan
Condenser Fan
Contactor
Compressor
Contactor
Condenser
Fan Motor
Stop
Tripped
Faulty
Faulty
Running
Stop
Faulty
Blown
Tripped
Faulty
Running
Kommentare zu diesen Handbüchern