McQuay PDHA Spezifikationen PDF herunterladen (Seite 34)

Accessory – PDAF/PDHF Flat Top 16" × 42"

Catalog 1300-1 / Page 34 of 42

ExtendAire™ Kit

The ExtendAire plenum system is internally lined

with 1/4" (6mm) berboard, 6 lb. (13.2 kg) density

to prevent condensation on the exterior surface.

Factory painted Antique Ivory, matching the nish

of the basic cabinet. Each extension section is

furnished in two pieces such that the rear half

can be fastened to the wall and the front half then

snapped in place without the use of screws or tools.

Duct cross-sectional dimension is 4½" × 7½". The

installer can select the number of active grilles in

the primary discharge section that will provide

diversion of the specied percentage of air to the

adjoining room outlet.

The percent air diverted can be adjusted from

24% to 50% as outlined in the selection table.

A. ExtendAire section primary discharge end cap

B. Cabinet front panel

C. Touchpad control

D. Communication cord

E. Removable discharge grilles

F. “T” bar hold-down clamps

G. Extension section connection “dimples”

Typical ExtendAire Application

Typical ExtendAire Congurations

Side Wall Outlet Assembly

Baseboard Outlet Assembly – Masonry Wall Construction

Baseboard Outlet Assembly – Panel Wall Construction

Shelf Discharge Assembly

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40 41 42

Keine Kommentare

McQuay PDHA Spezifikationen Seite 34